Three power off stalls straight ahead attempted. Second one didn’t really stall. On the first one, the wing dropped to the right while entering the stall and I inadvertently corrected through left rudder while also relaxing back pressure to break the stall. Steve formalized this and showed me stalls on a turn on both right and left turns. Stall on a left turn could lead to a spin if one is not careful. I tried a couple of stalls on a right turn before we moved to engine out simulation.

First, trim for a 65kts glide speed. Next, check the usual suspects for why the engine might be out – fuel selector, mixture, magnetos. If you have ruled these out as probable causes, find out the wind direction and quickly scout for a place to land. Preferably land into the wind. We picked out a field that had stubble and eliminated other fields that were green, or had been plowed recently. Since the field was pretty close to where we were, we did a 360 degree turn and after confirming that we would land there comfortably, we pushed the throttle. The track log below ends right after we started climbing out.

Finally, a few touch-and-go’s at Livermore. We were given 25L and left closed traffic after the first landing. I didn’t remember the controller’s instructions and inadvertently turned final for 25R. Steve hurried my turn and fortunately there was nobody else at that time on approach to 25R. On another pattern, the controller asked us to turn crosswind and when I hesitated, Steve banked quickly left. Why we got that instruction is irrelevant but that is exactly what I was analyzing. These were two good lessons in staying vigilant and reacting quickly.