As we flew over the Tracy airport, we noticed that it has now been re-opened after the runways were resurfaced and painted. Srinath started off by performing steep turns near Tracy. Next was slow flight, stall in the clean configuration and an approach to landing stall. Here is a sequence of steps for an approach to landing stall – first establish a steady descent, lower RPM to the airport pattern rate, full flaps and then trigger the stall. For recovery, drop the nose to break the stall, turn off carburetor heat, full power and minimize altitude loss.
Steve pulled off power simulating an engine out situation. Then a few landings at New Jerusalem followed by ground reference maneuver – turns around a crop circle, then turns around a point.
Upon landing at Livermore, we saw a very rare aircraft taxiing past us. It was a Bellanca Aries (N250DJ) – only one of 2 still flying out of the 4 aircraft ever made. This one was owned by Jim Rhoades of Livermore. See more details on this blog.
Last week on September 8, Srinath flew a bunch of touch and go’s at New Jerusalem. One was a “there is a cow on the runway” go-around.
We took off today and flew the usual right downwind departure. While flying over brushy peak, traffic controller alerted us to traffic in the vicinity which took us a while to locate. By that time we neared Tracy and Steve observed that the runways which had been closed for re-surfacing were getting ready and now being painted.
Today, Srinath had a chance to practice soft field takeoff and landings at New Jerusalem. Steve demonstrated it first and then let Srinath try it out a few times. On the way back to Livermore, we chatted quite a bit about how these require some of the most finessed piloting techniques.
After reviewing audio from the previous flight’s recording, we determined that the intercom was not working on the rear inputs. We can only hear the radio come through so unfortunately none of the cockpit chatter was recorded. While I squawked about this issue, since the plane is owned by Five Rivers Aviation it is really up to them to fix it.
Departed Livermore in the evening into a headwind. We flew our regular course towards Byron but the ASOS reported winds were too strong from 220 at 15 gusting to 21. Steve decided we should head towards New Jerusalem instead so we banked right over Fore Bay and did two sets of steep turns to the left then to the right. Followed by slow flight with shallow turns, power-off stall, a stall on right turn and a power-on stall. Then we did an engine out simulation.
By now the Byron area winds have increased to 20kts@220. We shot a straight in landing on Rwy 23. It was really bumpy over Fore Bay and more so as we approached the runway. We ended up being too high so the first approach and a landing wasn’t salvageable. We did a go-around and gave it one more try (good landing this time) before heading back to Livermore.
The Flying Particles club has added a new 1976 Cessna 172N Skyhawk. Unlike N25ES which was owned, the club has leased N906MD from Pete Sandhu at Five Rivers Aviation, LLC who is going to soon open and operate a new FBO out of the Livermore airport. 6MD has the same 180hp Lycoming 0-320 Series engine as 25ES but it is equipped with Garmin GNS-430 GPS.
Srinath flew 6MD today and it has been almost 3 months since Srinath last flew. His last flight was the solo on May 28. So he went back to brushing up on air work – power off stalls, stalls in the landing configuration and power-on stalls. Then we did an engine out simulation and after a couple of landings at Byron, we returned to Livermore.
N25ES has now been determined by the insurance assessor as a total loss and the club is in the process of finding a replacement 172. Steve was supportive when I asked if I could fly the club’s 1981 Cessna 152 (N6475Q) in the interest of staying in touch with my flying skills. I flew the 152 for the first time on July 24 to get a feel for the plane. I had not remembered to charge the batteries on my GoPro the previous night so there is no video archive from that first-time experience.
N6475Q is different from N25ES in many ways. For starters, it is a 2-seater aircraft (vs. 4-seat) and has a significantly lighter empty weight of 1165lbs (vs. 1459lbs). The plane is very sensitive to control inputs because of its light weight and the ride is also bumpier as it is easily tossed around by wind. The seats feel like they are almost at floor level with the legs pretty much extended straight ahead to the rudder pedals. I found it harder to get in and out of the plane. Seats slide front-to-back and the backrest has a single reclining position flopping flat on the seat in order to reach the luggage compartment. Front seats on the 172 have height adjustment, seat back reclining angle adjustment and they slide front-to back. The engine is a 115hp Lycoming 0-235 (vs. 180hp Lycoming 0-320 series). The most noticeable difference was during climb outs after takeoff due to the weaker engine. I’m used to a regular climb on the 172 but the angle of attack has to be much shallower on the 152 in order to avoid a power-on stall. Roughly 67-70 kts Vy for the climb (vs. roughly 76-80 kts) and 60 kts on the landing approach (vs. 65 kts). Right after takeoff, we needed to level off to gain airspeed before climbing out.
I’m flying 75Q today again and we did a bunch of touch-and-go at Livermore. Towards the end we were switched to runway 25L and on the last approach, I was way too high and too fast so I did a go-around and requested tower to switch us to 25R for a full-stop.
A couple of days ago on June 30 we did a bunch of landings at Livermore. All them were decent or better, with one of them very good that Steve didn’t feel compelled to give me any instructions.
We started today with steep turns, power-off stall and then a simulated engine-out landing at Byron. On this approach we had quite a bit of altitude to lose. We tried a slip but that didn’t bring us down much because of headwinds. Then we tried S-turns to lose altitude. After 4 landings, we decided to head to New Jerusalem. It was a warm and cloudy day. The density altitude at Tracy was reported as 1600′. Reflecting on the landings at Byron I suggested that maybe extending downwind would have made it easier to land. Steve was emphatic (7:34 into the video) that that was not only necessary but it will provide more opportunities to botch a landing.
On the first landing at New Jerusalem, I came down hard and bounced up quite a bit. I didn’t react quickly so Steve shoved in the throttle (8:24) and did a go around. Rightfully he gave me an earful. The second landing was ok – flared up a little too much but was able to bring the plane down just fine. After two more good landings, Steve endorsed me to fly solo.
It was unnerving to hear Steve ask me to fly solo but once I got into the cockpit and started the preparations, all such nervousness dissipated. During the flight there was so much to mentally manage that there was no time to feel nervous. I felt ready to handle it with all the training I’d received. The first landing was alright but on the second landing I bounced. And bounced high. Thankfully Steve’s words must have stuck in the back of my mind because I immediately pushed the throttle forward and did a go-around. The nose wanted to point way high up with full flaps deployed for the landing and I remember pushing forward hard on the yoke to fly nearly level and build up airspeed before climbing and slowly retracting the flaps a notch at a time. Perhaps I came in too fast and too flat causing the serious bounce. Since I did a go-around, I decided to do two more landings for a total of 4. They were not great but I managed to make them stick. The rest of the flight back home was uneventful.
This unfortunately ended up being my last flight on N25ES. In the following week another member of my flying club flew the plane and while practicing touch-and-go at Livermore bounced hard on a landing. The plane porpoised but the pilot did not attempt a go-around expecting to salvage the landing. The nose gear touched down first and the prop stuck the tarmac. The pilot was fortunately alright. He was a low-time pilot (having recently earned his private pilot’s license on the Cessna 152 and only a couple of hours of experience on the 172) and didn’t realize the seriousness of what had just happened. He did a few more touch-and-go before calling it quits. Later inspection revealed that the tip of one prop had broken off and the firewall had buckled. The plane ended up as a total loss and an insurance claim. The club has started a search for a replacement 172.
PS: In case you are wondering about the title of this blog, check out (9:37) into the pre-solo video.
Today the winds were from 280 @ 6kts and the controller cleared us for right closed traffic on runway 25R. We were #2 behind another inbound aircraft and I started off being too flat on the landings. On one of the early landings, I ballooned up due to too much flare too soon and Steve pushed the power in to do a go-around. We were then #2 behind a Beechcraft Baron and the tower changed us from 25R to 25L and left closed traffic. After a landing, the tower gave us the option to switch back to 25R which we gladly took.
After a few landings and one real greaser, Steve took the plane just to give me a breather. He did a short approach to hand the plane back to me quickly for more touch and go’s. I did another greaser landing and the controller switched me to 25L promising to switch me back to 25R after one pattern. But soon the controller came back on the radio and asked us to follow a LearJet to 25R. We called it quits after that final landing.
We started a right closed traffic pattern at Livermore around 5:45pm and there was quite a bit of air traffic in the area. The landings were all below average but it was good to get some experience dealing with the traffic. I’m still trying to figure out the flare just before touchdown. By the time I came around for the fifth landing, the traffic was pretty much gone. My radio work was quite shabby. In fact, I could chalk this video up as Radio Bloopers.
One time we were cleared to land but on final the tower asked us to go around – presumably the traffic behind turned out to be faster than the controller initially thought. On the next approach, I flared a little too much and I ballooned up a little too much just above the runway. So I immediately did a go-around without prompting from my instructor.
Just before we ended for the night, Steve asked the tower controller to show me light gun signals. We saw a Green flash and then a Red flash. Technically, this means “Exercise Extreme Caution“. A steady Green would have cleared us to land instead. We landed anyway because our radios were still working and we got clearance from the controller who showed us the light gun signals.
Tonight I flew my first night cross country. Days were long being we were close to summer solstice so we agreed to meet Steve in the hangar at 9pm. After pre-flight we were anticipating a takeoff around 9:30pm (which would have made it a true night flight) and arriving back in Livermore close to midnight. The route was Livermore (KLVK) to Hollister (KCVH) to Gustine (3O1) and back to Livermore. I’d filled out my cross country checklist, listened to 1-800-WX-BRIEF and captured notes for preparation.
The departure route was to follow I-580 and then I-680S but instead we took off from 25R, turned left crosswind and decided to cut across over Mission peak to I-680. Winds were from 260 @ 9kts which was a direct crosswind on our course. Consequently we didn’t climb very well and the airspeed was only 65kts which bothered us. So we banked to the right into the wind to gain altitude. Thanks to ForeFlight on our iPad in the cockpit, we were able to identify a FedEx and a VirginAmerica jet that crossed our paths. In fact, we even felt a slight bump (turbulence) from the FedEx’s wake turbulence as we crossed its path about 2000′ lower.
Once we crossed over Mission Peak, we stayed just west and parallel to the foothills since further west would put us in the approach path for flights into San Jose (SJC). South County airport was in sight and would have been a likely location to land if we ran into any emergencies. US 101 was also beneath us and as we neared Hollister, Hwy 152 was another emergency landing option. Although, it was backed up with traffic and police cars flashing lights. We landed straight into Hollister and then flew a right pattern out and to the east towards Gustine.
Hollister to Gustine tracked us over dark no man’s land. Steve wanted me to closely follow Hwy 152 since we were flying over hilly terrain and a large reservoir. Gustine was a little bit hard to find, but not as hard as finding Kingdon when Srinath flew his night cross country last month. I had remembered the airport was just past I-5 on the eastside and keying the mike turned on the runway lights making it possible to spot. However I had gained quite a bit of altitude so we decided to fly around the airport to lose altitude, and also to note the state of the windsock. We couldn’t see it clearly but it appeared there were no winds. So I decided to land on Rwy 36.
The approach was not great. I was too high and not well lined up so I decided to go around. This time Steve was able to confirm that the windsock was limp. No winds to speak of. On the downwind leg it seemed that I was not parallel to the runway and that might be why I had trouble with the last approach. This time I managed to land but it was a bad one – we bounced.
The last leg back to Livermore was mostly uneventful. We followed I-5 up to Tracy and then cut across over Altamont pass. The night was so cool and the flight so smooth (except for a little bit of wind turbulence as we approached Tracy) that Srinath fell sound asleep in the back seat.
We started off with Steve handing me stylish eyewear i.e. flying under the hood. After maintaining a heading and then tracking a VOR, I practiced two stalls in the clean configuration and recovery. Using only instruments under the hood. Then I practiced an approach to landing stall. First by initiating a descent, slowing down to 1500rpm and deploying flaps. The idea is to simulate a landing approach. Then pulling up the plane in this configuration and initiating a stall the plane. Recovery is similar to a stall in the call configuration with the exception that we have flaps deployed. So slowly retract flaps step by step when a climb has been achieved.
Next, I practiced slow flight with shallow turns. And then Steve pulled the power out simulating an engine out situation. We scouted a field and when we got pretty low, Steve pushed the throttle and we headed over Byron.
The winds were really strong at 20kts but fortunately it was a headwind on Rwy 23. Still the ride was really bumpy, perhaps the bumpiest of all our flights thus far. We practiced a couple of touch-and-go and then headed to Livermore for a couple more.
On the second touch and go at Livermore, we ballooned after touchdown due to the wind so Steve immediately did a go-around. I wasn’t quick enough to react and this was a good learning experience. After one more landing, we called it quits for the day.
Crab Tales 